Hydromotion - Fluid Swivels


	SWIVEL PRODUCT SPECIFICATION QUESTIONNAIRE Please supply information as requested in the list below. This will help Hydromotion properly evaluate your new product and application requirements. Please answer questions as thoroughly as possible. It is not necessary to be brief. Also, please add any other items that you feel are appropriate to your particular application. A Hydromotion application engineer/designer should discuss the particulars of your application to insure that your requirements are met. A SKETCH or DRAWING is very helpful. Please send one, if it is available. Thank you. I you would prefer, please click here to download a printable copy. Fill it out, and fax it to us at (610) 948-6733.
	Company Name
	Engineering Contact Name*
	Phone Number*
	FAX Number
	Email Address
	* Indicates a required field
	Description of Application
	Is the application for a new swivel design or a replacement swivel design?
	Other Special Application Requirements
	Prototype delivery date required
	Estimated Annual Usage
	Target Price (NOT MANDATORY)

Hydraulic / Other Liquids & Gases?

If there are pressure spikes, what is (are) the maximum values (PSI)?

Will the swivel experience rapid pulsating/hammering?
(attachment of hydraulic tools, non-standard operation cycles, etc.)

If there is a relief vale, what pressure is it set to?

Fluid Cleanliness ISO Level Required
(particles / millileter: 2 or 3 number - set code)

Is there a return line?

Please fill out the table below for port specifications:

Port#	Port Type	Media	Pressure (PSI)	Rotating Under Pressure	Flow (GPM)	Size	Function
1	Hydraulic Water Gas
2	Hydraulic Water Gas
3	Hydraulic Water Gas
4	Hydraulic Water Gas
5	Hydraulic Water Gas
6	Hydraulic Water Gas
7	Hydraulic Water Gas
8	Hydraulic Water Gas
9	Hydraulic Water Gas
10	Hydraulic Water Gas
11	Hydraulic Water Gas
12	Hydraulic Water Gas

Physical Characteristics

If possible, please provide a drawing to clarify the following information:

What is the mounting / turning method?
Port layout - where do the ports need to be located (i.e.angles / lengths from end, etc.)?
What is the final orientation of the center stem (body) to the casing (housing) for ease of installation?

Attachment:

Through Hole
Is there a through hole?	Purpose of the through hole?	Is it centered?

Diameter (inches)

Motion
What is the operational RPM?

Motion Type	Direction of Rotation



Temperature (°F)

Swivel Operating High Low	Outside Ambient High Low

Are there any overall restrictions in length or diameter of swivel?
Are there any other restrictions relative to swivel size?
Are there any environmental conditions which may affect the swivel?
Is the body or housing held stationary? (NOTE: It is required to have one end of the swivel (body or housing) floating to avoid side load conditions and premature wear)
Is the swivel mounted manifold (body fluid outlet end) up or down?
Are cap plugs or special plugs required for final shipping/storage?
Any special paint or finishing requirements? (Standard color is black enamel paint)
Are there any special packaging requirements?
Are there any special shipping instructions?

Electrical Circuits

Do you require a position-sensing system (i.e., radially locating the orientation of boom)?

Circuit#	Gauge	Color*	Lead Length(in) In	Lead Length(in) Out	Voltage	Amperage	Type of Connector / Terminator	Function
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28

*NOTE: Efficiencies are improved with the use of numbered circuits in lieu of color coded circuits.

Hydromotion Inc.
85 East Bridge Street
Spring City, PA 19475
(866) 931-5500 (Toll Free)
Fax: (610) 948-6733